G19
GOINGMAKE Bench Dog Clamp, 3/4 in
Holds work flat on a 3/4 in dog-hole bench
A grid of holes, then a clamp in any one
A bench top drilled with a grid of dog holes holds work anywhere on its surface. The dog hole guide drills that grid square: extension rails set the first row from the edge without measuring, and position pins in the last holes set the next, at spacings from 64 to 256 mm.
Pick the hole size first and keep it: the guide comes for 20 mm dogs, common on MFT-style tops, or 3/4 in dogs. The bench dog clamp has a 3/4 in rod, so it goes with the 3/4 in grid, and it holds stock up to 1-3/4 in thick under soft pads.
These jigs come from drill guides and clamps and sharpening in the GOINGMAKE jig line.
Questions
Questions about the GOINGMAKE bench dog tools
Do you get a bit with the GOINGMAKE dog hole guide?
Yes. Each kit has the drill guide, two extension rails, four position pins and a hole boring bit in its own size, 20 mm or 3/4 in.
Will the GOINGMAKE bench dog clamp fit your 20 mm holes?
No, its rod is 3/4 in. Pair it with the 3/4 in dog hole guide.