Filter
GOINGMAKE Compact Miter Gauge, 14 in Fence
Short fence and bar for benchtop saws
TSMG5ULTRA
GOINGMAKE Professional Miter Gauge
Telescoping fence for long runs of panel crosscuts
0727B
GOINGMAKE Miter Gauge with 18 in Fence
Fixed fence and flip stop for repeat parts
0727A
GOINGMAKE Extendable Miter Gauge, 18 to 32 in
One gauge for short parts and wider boards
0E4455
GOINGMAKE Long Fence Miter Gauge, 21 to 38 in
Our longest fence, for tabletops and wide panels
0122B
GOINGMAKE Small Miter Gauge, 12 to 21 in
Jobsite-size gauge whose fence reaches 21 in
0122A
GOINGMAKE Small Miter Gauge, 12 in Fence
Smallest gauge in the range, for portable saws
DF1230B
GOINGMAKE Compact Miter Gauge, 14 to 24 in
Mid-size gauge that stretches for the odd wide board
GOINGMAKE Table Saw Dial Indicator Gauge
Measures blade and fence against the miter slot
One slot, three jobs
Your table saw has a 3/8 x 3/4 in miter slot on each side of the blade, and every jig on this page rides in it. A miter gauge pushes a board across the blade for crosscuts and angles. The thin rip jig locks in the slot in front of the blade and sets the width of the next strip from a roller bearing. The dial indicator slides along the slot to show how far the blade or the fence sits from parallel.
Start with the alignment: a blade that is out of line with the slot spoils every cut the other jigs make. Then pick a gauge by the size of your saw table and the widest board you crosscut, and add the thin rip jig if you cut banding, slats or inlay strips in batches.
These jigs come from miter gauges and saw jigs and guides in the GOINGMAKE collection.
Questions
Questions about the GOINGMAKE table saw jigs
Which GOINGMAKE table saw jig should you buy first?
Check the blade first: if it is not parallel to the miter slot, no gauge cuts square. The dial indicator shows it. After that, the miter gauge that fits your saw, and the thin rip jig if you cut strips.
Will every GOINGMAKE table saw jig fit your miter slot?
Yes, the 3/8 x 3/4 in slot most table saws use. The thin rip jig also fits 1/4 x 3/8 in T-slots.