GOINGMAKE Compact Miter Gauge, 14 in Fence
Short fence and bar for benchtop saws.
- Fence
- 360 mm (14 in) aluminum
- Miter bar
- 360 mm, adjusters front, middle and end
- Angle stops
- 11 positive stops: 90, 60, 45, 30, 22.5, 15 and 0° each side
- Flip stop
- Magnifier and pointer, locating pin for angled faces
Description
Description
On a benchtop saw, box sides and frame rails rarely need more than a short fence. The Compact Miter Gauge matches a 360 mm (14 in) fence to a 360 mm bar. The whole gauge is easy to store and to carry to the next job, and it still crosscuts a part wider than your hand.
Short parts are where a flip stop pays off. Its pointer reads under a magnifying glass, it locks solid for a run of repeat cuts, and a locating pin catches the end of a mitered piece. To zero it, set the pointer on 0 and lock it. Then move the fence until the stop touches the blade, using the 1 to 3 mm gap we built in.
Angles lock with a plastic handle against metal stops at 90, 60, 45, 30, 22.5, 15 and 0° to each side, eleven in all. The laser-engraved inch and mm scales handle anything in between. Adjusters at three points along the bar fit it to a 3/8 x 3/4 in slot.
Specifications
The GOINGMAKE Compact Miter Gauge, 14 in Fence, by the numbers
| Fence | 360 mm (14 in) aluminum |
|---|---|
| Miter bar | 360 mm, adjusters front, middle and end |
| Angle stops | 11 positive stops: 90, 60, 45, 30, 22.5, 15 and 0° each side |
| Flip stop | Magnifier and pointer, locating pin for angled faces |
| Scales | Inch and mm, laser engraved |
| Material | Aluminum alloy |
The Compact Miter Gauge, 14 in Fence sits with 8 other jigs on the miter gauges shelf of the GOINGMAKE range.
Questions
Questions about the GOINGMAKE Compact Miter Gauge, 14 in Fence
Is the GOINGMAKE 14 in Compact Miter Gauge small enough for your benchtop saw?
It was sized for one: the fence and the bar are both 360 mm (14 in). The bar fits a 3/8 x 3/4 in T-slot or U-slot, and adjusters at the front, middle and end set its fit.
Can the GOINGMAKE Compact Miter Gauge repeat short parts for your boxes?
Yes. Lock the flip stop at a length on the 14 in fence and every box side stops at the same mark. See choosing a miter gauge for when a longer fence helps.
A table saw cuts fingers as easily as wood. The agencies below put the numbers on it and say what keeps hands out of the line of the cut.
More from the shop
You may also need
TSMG5ULTRA
GOINGMAKE Professional Miter Gauge
Telescoping fence for long runs of panel crosscuts
0727B
GOINGMAKE Miter Gauge with 18 in Fence
Fixed fence and flip stop for repeat parts
0727A
GOINGMAKE Extendable Miter Gauge, 18 to 32 in
One gauge for short parts and wider boards
0E4455
GOINGMAKE Long Fence Miter Gauge, 21 to 38 in
Our longest fence, for tabletops and wide panels