GOINGMAKE Bench Dog Clamp, 3/4 in
Holds work flat on a 3/4 in dog-hole bench.
- Rod
- 3/4 in, CNC-machined
- Clamps
- Stock up to 1-3/4 in
- Pads
- Soft pads against marks
- Build
- Aluminum
Description
Description
Sanding a panel or drilling a part on a dog-hole bench is easier when the work cannot slide. The Bench Dog Clamp drops its CNC-machined 3/4 in rod into any 3/4 in dog hole and presses the stock down against the top, wherever on the grid the part happens to sit.
Clamping height adjusts for boards up to 1-3/4 in thick. Soft pads on the jaw protect the face of the wood from marks, which matters on a finished panel. Its fast action lets you clamp and release between operations without a crank, so moving a part across the bench takes seconds.
It holds parts for cutting, sanding, drilling and joinery, from a small box side to a cabinet door. The body is aluminum. If you are building the top too, our Bench Dog Hole Drill Guide in 3/4 in drills holes this clamp fits. A pair of clamps on opposite ends holds a long board flat for sanding.
Specifications
The GOINGMAKE Bench Dog Clamp, 3/4 in, by the numbers
| Rod | 3/4 in, CNC-machined |
|---|---|
| Clamps | Stock up to 1-3/4 in |
| Pads | Soft pads against marks |
| Build | Aluminum |
| Material | Aluminum alloy |
| Model number | G19 |
The Bench Dog Clamp, 3/4 in sits with 2 other jigs on the clamps and sharpening shelf of the GOINGMAKE catalog.
Questions
Questions about the GOINGMAKE Bench Dog Clamp, 3/4 in
Will the GOINGMAKE bench dog clamp fit your 20 mm dog holes?
No. The rod is 3/4 in and made for 3/4 in dog holes. Our Bench Dog Hole Drill Guide drills either size, so a new top can be laid out for this clamp.
How thick a board can you hold down with the GOINGMAKE bench dog clamp?
Up to 1-3/4 in thick. Set the clamping height to the board, and the soft pads press on the face without marking it, even on a finished panel.
More from the shop
You may also need
GM-G140
GOINGMAKE Corner Clamps, 45 and 90°
Holds two boards at 90 or 45° for glue-up
