GOINGMAKE Portable Drill Guide, -60 to 60°
Angle holes from 60° to -60° by hand.
- Chuck
- 1/2 in self-locking
- Angles
- Positive stops at 90, 60, 45, 30, 15 and 0°, and -15 to -60°
- Depth
- Built-in depth stop
- Base
- V-groove for round stock, rubber pads, mounting holes
Description
Description
Some holes cannot go under a drill press: a leg already glued into a table, a post set in the ground, an angled hole through a wide panel. The Portable Drill Guide, -60 to 60°, brings the press to the work. Your bit goes in the guide's own 1/2 in self-locking chuck, and your 3/8 or 1/2 in cordless drill turns it.
Positive stops sit at 90, 60, 45, 30, 15 and 0°, and on the other side at -15, -30, -45 and -60°. Two locking handles hold the setting so the angle does not creep as you press. A built-in depth stop sets how far the bit travels. It keeps a dowel hole from breaking out of the far face.
The base does more than sit flat. A V-groove centers a dowel or pipe under the bit, rubber pads keep the guide from walking on a smooth top, and mounting holes let you screw it to a bench for a run of holes. On a small part you can hold the guide with one hand and drill with the other.
Specifications
The GOINGMAKE Portable Drill Guide, -60 to 60°, by the numbers
| Chuck | 1/2 in self-locking |
|---|---|
| Angles | Positive stops at 90, 60, 45, 30, 15 and 0°, and -15 to -60° |
| Depth | Built-in depth stop |
| Base | V-groove for round stock, rubber pads, mounting holes |
| Drills | 3/8 and 1/2 in cordless drills |
| Material | Aluminum alloy |
| Model number | 01054 |
The Portable Drill Guide, -60 to 60° sits with 4 other jigs on the drill guides shelf of the GOINGMAKE collection.
Questions
Questions about the GOINGMAKE Portable Drill Guide, -60 to 60°
Can you drill a hole through the center of a dowel with the GOINGMAKE angle drill guide?
Yes. The V-groove in the base centers round stock under the bit. Set the angle stop to 90° for a straight cross hole and the depth stop for how far it goes.
Will your cordless drill work in the GOINGMAKE portable drill guide?
It takes 3/8 and 1/2 in cordless drills. The bit goes into the guide's own 1/2 in self-locking chuck, and your drill drives it from above.
A bit that catches spins the stock in your hand. Clamp the work, and collect the dust the bit throws.
More from the shop
You may also need
G2
GOINGMAKE Shelf Pin Jig, 1/4 in
Seven shelf pin holes per placement, 32 mm apart
0812
GOINGMAKE Drill Guide for Straight Holes
Square holes in parts too big for a press