GOINGMAKE Track Saw Parallel Guide System
Turns your track saw rail into a rip fence.
- Rip range
- 0 to 53 in (0 to 1350 mm), standard and narrow scales
- Flip stop
- Micro-adjustable, 0.001 in (0.0254 mm), magnifier
- Zero setting
- Zero-calibration knob
- Scales
- Separate imperial and metric
Description
Description
Breaking down a 4x8 sheet of plywood into cabinet sides usually starts with measuring and marking both ends of every cut. The Track Saw Parallel Guide System replaces that with a fence. Two brackets lock onto your guide rail, T-tracks run out to the edge of the sheet, and a flip stop on each track sets the cut line parallel to that edge.
Cuts repeat from 0 to 53 in (0 to 1350 mm). Imperial and metric scales are separate, and each is split into standard and narrow ranges: 12 to 53 in and 0 to 12 in, or 300 to 1350 mm and 0 to 300 mm. The flip stops adjust in 0.001 in (0.0254 mm) steps under a magnifier.
A zero-calibration knob sets the scale to the rail edge once, and the brackets fit Festool, Makita, Milwaukee, Triton, Powertec and WEN guide rails. Join one to four tracks, depending on how far the stops need to sit from the rail. Every strip off the sheet then comes out the same width as the one before it.
In the box
In the box
- 2 connect brackets
- 8 T-tracks
- 2 flip stops
- 12 T-track connectors
- 2 extension rods
Specifications
The GOINGMAKE Track Saw Parallel Guide System, by the numbers
| Rip range | 0 to 53 in (0 to 1350 mm), standard and narrow scales |
|---|---|
| Flip stop | Micro-adjustable, 0.001 in (0.0254 mm), magnifier |
| Zero setting | Zero-calibration knob |
| Scales | Separate imperial and metric |
| Rails | Festool, Makita, Milwaukee, Triton, Powertec and WEN guide rails |
| Material | Aluminum alloy |
| Model number | TSPG58 |
In the box
- 2 connect brackets
- 8 T-tracks
- 2 flip stops
- 12 T-track connectors
- 2 extension rods
The Track Saw Parallel Guide System sits with 3 other jigs on the saw jigs and guides shelf of the GOINGMAKE lineup.
Questions
Questions about the GOINGMAKE Track Saw Parallel Guide System
Does the GOINGMAKE parallel guide fit your Makita or Festool rail?
Yes. The connect inserts slide into Festool, Makita, Milwaukee, Triton, Powertec and WEN guide rails and lock square. Other rails are not on our list, so measure yours against one of these before you order.
Can you rip a full 4x8 sheet in half with the GOINGMAKE parallel guide?
A 48 in sheet halves at 24 in, inside the 12 to 53 in standard range. Set both flip stops to 24 in and the cut runs parallel to the sheet edge. See repeat rips with a track saw.
A track saw is a circular saw on a rail, and the same rules of support and kickback apply to it.
More from the shop
You may also need
GOINGMAKE Table Saw Dial Indicator Gauge
Measures blade and fence against the miter slot
0514
GOINGMAKE Track Saw Parallel Guide with Magnifier
Parallel guide that reads its scale at a glance
